Staad Pro V8i Ss6 Technical Reference Manual

  1. Staad Pro V8i Ss6 Technical Reference Manual Rapid Overview

TableofContents 5.33ReferenceLoadCases-Application 669 5.34FrequencyCalculation 670 5.35LoadCombinationSpecification 672 5.36CalculationofProblemStatistics 676. You need to click on the blue Download button on the right hand top immediately above the text which says STAAD.Pro v8i Select Series 6 - Technical Reference Manual. Ensure that you are logged in. Offline nl htwe over 4 years ago. TableofContents 5.3UnitSpecification 282 5.4Input/OutputWidthSpecification 284 5.5SetCommandSpecification 284 5.6DataSeparator 294 5.7PageNew 295 5.8PageLength/Eject 295.

JavaScript must be enabled in order to use this site.

Staad pro v8i ss6 technical reference manual user

Please enable JavaScript in your browser and refresh the page.

This section contains details of the STAAD.Pro commands used to create STAAD input files which are read by the STAAD engine.

Note: This section was previously included as Section 5 of the Technical Reference Manual. For convenience, the section numbers from that manual are maintained here with 'TR.' in place of '5.' for the chapter number.

Introduction

Manual

The STAAD.Pro graphical user interface (GUI) is normally used to create all input specifications and all output reports and displays. These structural modeling and analysis input specifications are stored in STAAD input file – a text file with extension, .STD. When the GUI opens an existing model file, it reads all of the information necessary from the STAAD input file. You may edit or create this STAAD input file and then the GUI and the analysis engine will both reflect the changes.

Staad pro v8i ss6 technical reference manual trm

The STAAD input file is processed by the STAAD analysis 'engine' to produce results that are stored in several files (with file extensions such as ANL, BMD, TMH, etc.). The STAAD analysis text file (file extension .ANL) contains the printable output as created by the specifications in this manual. The other files contain the results (displacements, member/element forces, mode shapes, section forces/moments/displacements, etc.) that are used by the GUI in the post processing mode.

TR.1 Command Language Conventions
TR.3 Unit Specification
TR.5 Set Command Specification
TR.7 Page Control Commands
TR.9 No Design Specification
TR.11 Joint Coordinates Specification
TR.13 Plate and Solid Elements
TR.15 Redefinition of Joint and Member Numbers
TR.17 Rotation of Structure Geometry
TR.19 User Steel Table Specification
TR.21 Element/Surface Property Specification
TR.23 Axial Member Specifications
TR.24 Element Plane Stress and Ignore Inplane Rotation Specification
Staad Pro V8i Ss6 Technical Reference ManualStaad Pro V8i Ss6 Technical Reference Manual
TR.26 Specifying and Assigning Material Constants
TR.28 Rigid Diaphragm Modeling
TR.30 Miscellaneous Settings for Dynamic Analysis
TR.32 Loading Specifications
TR.34 Frequency Calculation
TR.36 Calculation of Problem Statistics
TR.38 Change Specification
TR.40 Load Envelope
TR.42 Print Specifications
TR.43 Stress/Force Output Printing for Surface Entities
TR.45 Printing the Force Envelope
TR.47 Size Specification
TR.49 Code Checking Specification
TR.51 Steel and Aluminum Take Off Specification
TR.53 Concrete Design Specifications
TR.55 Shear Wall Design

Staad Pro V8i Ss6 Technical Reference Manual Rapid Overview

Index of Commands